eLightbars Home

the Internet's largest lightbar, siren, and emergency equipment forum

Make a contribution

Forum options:    SearchSearch   Member listMember list  RegisterRegister  ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in

Notice: Thanks for your patience as we work to restore full service. In the mean time, please try out our new chat room.

How to sync. Whelen Linear 3 's


 
Post new topic   Reply to topic    eLightbars.org Forum -> Lightbars, LED lights, strobes, and beacons
Author Message
Chief Mike
Regular
Regular


Joined: 27 Feb 2006
Posts: 75
Location: China Grove TX
PostPosted: Sat 25-Oct-2008 18:55    Post subject: How to sync. Whelen Linear 3 's Reply with quote
I mounted these on the front grill 1 red & 1 blue on drivers side & 1 red & 1 blue on passanger side. I want the pattern to be an X. 2 blue flash together & 2 red flash together. How do I accomplish this? Good thing I know how to put out fires, cause I don't know anything about installing lights. Embarassed Thanks. Chief Mike.
Back to top    URL
R. Dodd 10-75 E.L.
Professional Upfitter


Joined: 16 Sep 2006
Posts: 2006
Location: Oakland, NJ
PostPosted: Sat 25-Oct-2008 19:03    Post subject: Reply with quote
connect all the grey wires together

then apply power to the white violet wire on the top left and bottom right for one sec. each
Back to top    URL
TNFF412N
Regular
Regular


Joined: 14 Jun 2008
Posts: 147
Location: Fayetteville, TN
PostPosted: Sun 26-Oct-2008 07:36    Post subject: Reply with quote
i honestly find it much easier to figure out what flash pattern you want before you put it on the vehicle. i set all the flash patterns and mark the light for where it goes
Back to top    URL
Kirk @ K&D Lighting
Regular
Regular


Joined: 21 Aug 2005
Posts: 964
Location: New York
PostPosted: Sun 26-Oct-2008 10:33    Post subject: Re: Reply with quote
[quote:7e675a0d4f=\"TNFF412N\"]i honestly find it much easier to figure out what flash pattern you want before you put it on the vehicle. i set all the flash patterns and mark the light for where it goes


I select the proper pattern(s) prior to mounting any lights. I also find it easier.
Back to top    URL
J. Thompson
Administrator


Joined: 27 Aug 2005
Posts: 3344
Location: Houston, TX
PostPosted: Fri 31-Oct-2008 05:57    Post subject: Reply with quote
Hey Chief.... Did you ever get this fixed?

I will be in San Antonio this weekend and if you still need help, I will try to meet up with you and help you get it resolved.

I'll be booked up on Saturday though. Don't know if I will be on shift at BBVFD or be assigned to Haz-Mat duties at the air show, but give me a holler if you need to.
Back to top    URL
Display posts from previous:   
Post new topic   Reply to topic    eLightbars.org Forum -> Lightbars, LED lights, strobes, and beacons All times are GMT - 6 Hours
Page 1 of 1

 

By accessing any part of this site, you acknowledge/accept the terms and conditions laid out in our site guidelines.

© Blake Barr, all rights reserved.