For Sale 34" Streethawk

[JennyCop]

http://www.ebay.com/itm/STREETHAWK-SHL-SERIES-B-LIGHTBAR-SYSTEM-ROTATING-LIGHTS-TESTED-WORKING-LOT-4-/161706887437?pt=LH_DefaultDomain_0&hash=item25a67b490d

 

[acklover]

A little pricey for a Streethawk...is it worth $125.00 since its a "mini"? 

 

[AJ3814]

Never seen a mini-hawk.... but for all their bulkiness, they certainly were visible..... I likey.....

 

[acklover]

My first bar was a street hawk from NC.

 

[lotsofbars]

This thing isn't worth that at all . . . maybe $80 shipped on a good day. You can just make mini streethawks by removing the center parts and collapsing the expandable frame. 

 

[EHFD_Tower_751]

This thing isn't worth that at all . . . maybe $80 shipped on a good day. You can just make mini streethawks by removing the center parts and collapsing the expandable frame. 

been there.....done that lol

got the frame to do another one.........and thats all i have lol

 

[ERIC6913]

This thing isn't worth that at all . . . maybe $80 shipped on a good day. You can just make mini streethawks by removing the center parts and collapsing the expandable frame. 

Right, but you need the stainless steel trim band to make it factory correct!

 

[StEaLtH2]

Not very familiar with the minis, did they have the four rotators usually?...

 

[JennyCop]

Right, but you need the stainless steel trim band to make it factory correct!

It's all about the details!

 

[EHFD_Tower_751]

Not very familiar with the minis, did they have the four rotators usually?...

i believe so, but im sure you could probaly get them with the cascade mirrors and 2 rotators.

The one i made had 4 rotators and all lower lights (alleys, TDs and rear flashers)

 

[chief1562]

And those domes could use a good wet sanding and polish

 

[lotsofbars]

Right, but you need the stainless steel trim band to make it factory correct!

That aren't worth over $10 shipped from anywhere.