cabunty
Member
I'm wondering, is there a way to make the HHS3200 step-through button presses to change the output on the Smartlogic flasher without having to close and open the relay every time? For example, Assign one button to Cruise lights, press 1 Cruise lights 50%, press 2 Cruise lights 100%, press 3 Steady flash?
I can get it to do this BUT I have to do one more press at the end and must program the HHS3200 to on and then off in between each mode and a final cycle of on and off to shut them off. I'm just wondering if there is an easier way?
Thx!
I can get it to do this BUT I have to do one more press at the end and must program the HHS3200 to on and then off in between each mode and a final cycle of on and off to shut them off. I'm just wondering if there is an easier way?
Thx!