Search results

No need to alter,just carefully remove rubber boot,and plug,pull apart,and route wire thru.There is enough room to follow factory wiring.We have done this on both Utility Interceptors,and Explorers.

The colored wires are: Green-Emergency light sense -supposed to be fused at 2a Blue-Siren sense-to optional detector Yellow-Officer mic record indicator light,usually mounted behind grille.Sends 12v White-Ignition sense-to be fused at 7 1/2 a Red-Main power-to be fused at 7 1/2 a...

I recommend checking out Troy Products.

If this harness also has a gray,and a shield,then it is the serial communications cable,designed for use with BL-627,IIRC.

Here is the Installation Guide for a Jotto Push Bumper:http://jottopublicsafety.gojotto.com/Shared/media/downloads/PJD_PB_PI_UTILITY_II.pdf

This is a Ford factory fuse panel.We had them ordered with all of our Crown Vics,and made sure the new Interceptors,both sedan and utility,were ordered with them.Originally,they came already connected to the Police fuse box.They were meant to be used split,half hot,half ignition.If you pry the...

My Bad.Thanks for the correction.

If it were for certain Constables around here,they would want to add a 49" lightbar,and six vertexes.

If the bundle contains six blunt cut wires,all black with colored stripes,green,red,blue,white,orange,and tan,then they are the wires intended for grille lights,siren driver,etc.They terminate in a gray,12 wire plug behind the lower center dash panel.If you go to watco.net,at the top of the...

My Bad,P.M. re-sent.

P.M.inbound.

You are welcome.

The Spectra control head bracket,07D80127N02,will work.I am not sure if the originals had longer forks,but all of the control heads we have,are affixed with the spectra mounts.

I stand corrected.The older Smart Sirens were 100 watt,and that is how we hooked up to two 100 watt drivers.

The installation manual specifies connecting the two speakers to be hooked up in phase,meaning connect the two white wires together,hook the black wire from one speaker to the blue wire,and the other black to the brown wire.

The plug and play module,that if installed,will be under the passenger side headlight.It controls both headlight,and tailight flashing.However,we have seen some pre fitted Tahoes with seperate headlight,and tailight flashers,with the tailight flasher being mounted just below the passenger taillight.

Sorry,re read your post.The plate is removable,so you can cut it,to use a console faceplate.We just decided not to.

Yes.We have done two of these,mounting an APX7500 control head,and a Tomar control head both,on that plate.

If it has the same access panel on top,and compartment with door,on the drivers side,as the Police Package,it can go there.We cut out the plastic behind the compartment door,leaving the frame,so the door could be put back on.We mounted a Tomar 940,an APX7500,a Blue Sea fuse block,and two relays...

You are welcome.Just looking over one of ours,and yes,the wire is green/white.

From what I can see in the picture,on Fords Upfitter Guide,You are looking for a Grey Plug,with an Orange/Green wire.It should be located behind/under the taillight,between the taillight,and the Power Point.To change it from hot all the time,to ignition,you seperate the plug,tape over exposed...

We mounted a Tomar Scorpion,using the mounting kit for the Impala.Most lightbar companies have impala hook kits.This was a 2012 Traveres by the way.

Yes,it comes with a bungee strap.

We use the Motorola Kit#RLN4884BSP01.It is the holder,mount,and strap,that comes with the RLN4884B charger,just without the electronics.

Just F.Y.I. I have done 20 of these so far,using the "behind the grille" frame brackets.When there is a push bumper,I remove the 6 10mm bolts from the top of the grille,and using tie wraps,pull the grille away from the front.When there is no push bumper,I use blocks of wood to wedge it.I have...

Actually,these are led lights made by Whelen,for Wheeled Coach.They are steady burn,until emergency lights are activated,then they flash.

Just F.Y.I.,It is Whelen part # 01-0685911-() Universal Mounting Kit

Thanks for the heads up,I just passed it on to our County Fleet.

Just IMHO,siren drivers do not make the best radio speakers.Depeding on use,we use Motorola waterproof speakers,or Atlas outside speakers,connected to a double position switch.

Just F.Y.I.,Sound Off,has a vehicle compatability chart on the website. You need to have Microsoft Office,on your computer,to view it.