Complete innards for a LC Patriot bar. 4 corner strobes, 4 500 strobes, 4 500 halogens, 2 supplies(one bad outlet on one supply) 5 500 5mm(2b,1a,2r) LC board with all harnesses. Make me an offer. $23 shipping in the USA.
I have 2 XLP Inner Edges. 1 is all blue with TD for a PIU, no brackets $300 shipped in the USA and one all red with TD for a pre 2015 Tahoe with brackets $450 shipped. Both are LC direct wire. DM me. Thanks
Make me an offer. No partials. Offer is for it all. 2 R/A Linz6 1 red Linz6 2 5mm 500s in white 4 steady blue tir6 2 vertical lens tir3 in blue and 1 red/1 blue smart tir6. All worked last time I tested them which was a long time ago lol.
If it’s LC it’s most likely the board. You can’t program the corners to steady on a LC so it’s definitely not the programming of the bar. Check the outlet and trace the wires all the way back to the long white plug the light head harness comes out. If there are no issues with any of that go...
You cannot use either. The avenger isn't even a module but rather a lense in front of a board....dual Avengers use a single board for both sides...You need the original Inner Edge LIN6 modules and are snap in
Looking for a round 184 beacon motor. Same on as seen in the gear driven Aeros. Also need the center plate with both mirrors from the center of a 22I Aero 1 FOUND still need 1...cheap as possible please. Thanks for the help
Yes, the bulkhead mirrors. They semi-block the front flash on the inner most rotators so they were ordered without them by FD's due to how high up they were over your standard car.