ChargerLighting
Member
I've spent the last few days on this thing. I cut the frame down from a normal Smart Vector that had cut cables & more assorted problems. The LEDs & brackets are out of a FedSig Raydian that I parted out. I didn't cut any of the brackets, just drilled holes in them.
Federal never used this type of LED in their 3 pod Vectors; they always used Solaris LEDs. They used 3 modules on each outboard pod - from what I can tell - one facing the rear, one facing the front & one facing the side & 2 stacked in the front center.
Mine is set up the same way but with 2 facing each side instead of one.
I'm not done with this one yet, I have all the wires pulled but still need to order new domes, a LED flasher & have to put magnets & a cable on it.
I was also contemplating angling the top LED modules on the outboard ends if space allows.
Here it is as it sits now...




Federal never used this type of LED in their 3 pod Vectors; they always used Solaris LEDs. They used 3 modules on each outboard pod - from what I can tell - one facing the rear, one facing the front & one facing the side & 2 stacked in the front center.
Mine is set up the same way but with 2 facing each side instead of one.
I'm not done with this one yet, I have all the wires pulled but still need to order new domes, a LED flasher & have to put magnets & a cable on it.
I was also contemplating angling the top LED modules on the outboard ends if space allows.
Here it is as it sits now...




Last edited by a moderator: