911ep millennium question help please

Sta25ems

New Member
I have the last new version of the 911ep millennium light bar with the new cid. Now I just got it a few weeks ago and it worked fine. I went to install and seen one module was out then the whole bar won't light up. When I connect the wires some of the modules come on for a very split second then nothing. The controller lights up along with the power light to the cid but the N opplight does not come on like it did before I installed. Any help would be appreciated thanks.
 

tsquale

Site Minion
Platinum Supporter
@Sta25ems are you sure you have it wired back up correctly? RX and TX wires aren't mixed up? Good ground and power source (not a jumper pack).

Here is the install guide.
 

Attachments

  • 640004CID_InstallGuide.pdf
    233.3 KB · Views: 12
  • Millennium_InstallTabloid.pdf
    541 KB · Views: 9
OP
OP
S

Sta25ems

New Member
@Sta25ems are you sure you have it wired back up correctly? RX and TX wires aren't mixed up? Good ground and power source (not a jumper pack).

Here is the install guide.


If the motherboard would have went bad the fuses would have blew correct because all fuses are good
 

Online statistics

Members online
2
Guests online
86
Total visitors
88

Members online

Forum statistics

Threads
49,754
Messages
429,434
Members
17,803
Latest member
Marcfarr

Secure Browsing

Top Bottom