Hi all,
I have a CenCom Gold that has worked flawlessly for what I have needed it for. Until last night. Output 8 suddenly stopped working on a scene. The only items that output powers is the rear half of a liberty bar, LED tail light flashers and 4 TIR4 leds on the toolbox. So not a lot of current. I checked input voltage and it's present, but nothing on the outlet side. I'm pretty sure I can hear the relay engaging when I use the slide switch but no power output. The fuses on the ARM are fine and the manual says this output is "internally regulated". Has anyone had these go bad and had Whelen repair? Or is it not worth it? I checked the program software to make sure it was selected and all is fine there. Any help would be appreciated.
Thanks!
I have a CenCom Gold that has worked flawlessly for what I have needed it for. Until last night. Output 8 suddenly stopped working on a scene. The only items that output powers is the rear half of a liberty bar, LED tail light flashers and 4 TIR4 leds on the toolbox. So not a lot of current. I checked input voltage and it's present, but nothing on the outlet side. I'm pretty sure I can hear the relay engaging when I use the slide switch but no power output. The fuses on the ARM are fine and the manual says this output is "internally regulated". Has anyone had these go bad and had Whelen repair? Or is it not worth it? I checked the program software to make sure it was selected and all is fine there. Any help would be appreciated.
Thanks!