Check this out on EBAY

[chief1562]

Wish I had thought about doing this before some else.

Thin I would have left out the MR11 and the wiring would have been better.

But not a bad job.

 http://www.ebay.com/itm/Code-3-Federal-Signal-LED-Lightbar-Amber-Custom-Built-/111605132872?pt=LH_DefaultDomain_0&hash=item19fc2f2e48

 

[dmathieu]

LOL, I thought it might have been one of yours!

 

[Steve0625]

The tie-wraps holding the LEDs in place on one end is a bit hokey, but as you say, not a bad idea at all.

 

[chief1562]

LOL, I thought it might have been one of yours!

Believe me would have been a lot better in the fab dept.

But that does give me an idea for a new project.

Even if I have to (rip) barrow the idea.

 

[jmccarthy]

Im in the process of doing this with an old star minibar i had laying around

 

[EHFD_Tower_751]

and to think im gonna have an 420 shell once i get done putting the parts in a newer 420 shell (the base i have is damaged).

Not that i need anymore ideas...........already doing a custom LEDX2100 bar

 

[chief1562]

Im in the process of doing this with an old star minibar i had laying around

You mean like this https://www.youtube.com/watch?v=ma2JprLrkbE

and to think im gonna have an 420 shell once i get done putting the parts in a newer 420 shell (the base i have is damaged).

Not that i need anymore ideas...........already doing a custom LEDX2100 bar

Seen the base on EBAy

 

[jmccarthy]

You mean like this

Yes only im gonna try to cut the dome down so its not so tall

 

[chief1562]

Yes only im gonna try to cut the dome down so its not so tall

How you plan on mounting after?

 

[jmccarthy]

Not quite sure yet