Irishrover68
New Member
So, I just put power to the two AS2's that I recently picked up. All the lights work, but as another member said, he didn't recall them ever having an internal flasher to alternate the lights.
As I mentioned in my previous post, there are three wires editing the chassis on the rear of each light. Hot, ground, and a white wire. When I put the red and black to power, only one light illuminates, same when I hooked up the hot and white wire, only it was the other side that illuminated. When I connected the white to the ground wire, both lights illuminate simultaneously, but are dimmer than normal.
Here's my question. I want to get these to flash in a wig wag pattern. Do I just install a 537 flasher internally, and how in the world do I wire it up. I have less issues wiring a switch to LED's since it's either ground or positive triggered momentary to cycle patterns. Any help is appreciated. I had an AS2 a few years back that already had the cigar plug, and a flasher installed, so I'm assuming the person I bought it from installed it, although I'm not sure how much room there is inside.
As I mentioned in my previous post, there are three wires editing the chassis on the rear of each light. Hot, ground, and a white wire. When I put the red and black to power, only one light illuminates, same when I hooked up the hot and white wire, only it was the other side that illuminated. When I connected the white to the ground wire, both lights illuminate simultaneously, but are dimmer than normal.
Here's my question. I want to get these to flash in a wig wag pattern. Do I just install a 537 flasher internally, and how in the world do I wire it up. I have less issues wiring a switch to LED's since it's either ground or positive triggered momentary to cycle patterns. Any help is appreciated. I had an AS2 a few years back that already had the cigar plug, and a flasher installed, so I'm assuming the person I bought it from installed it, although I'm not sure how much room there is inside.