code 3 ta controller help

[generalblue21]

i was wondering if the code 3 ta controller suppose to look like this, to me i think i'm missing some thing. if someone could tell me how to wire it right and make it work that would be great.

 

[7d9_z28]

I have the same one. Really common, really easy. The diagram was right on the bottom of mine...


google search it, usually a manual will pop up


EDIT Page 5 should be the one http://www.code3pse.com/public/media/inst_as-847_839_6fl_arrowstik_t02784_rev_20.pdf

 

[chief1562]

This is like yours it just has the setup for AUX.hookup


the red wire from the TA and you put power in the same place on the controller.

 

[shues]

Remove the red wire from the green plug. Provide +12v DC to the ArrowStik via the red wire and red/white wire, and to the controller via the place in the green plug where the red wire came from. Connect the black on the ArrowStik controller to ground.

 

[generalblue21]

these are the wires for my code3 TA (red, red/white, yellow, orange, blue, brown, purple) so if anyone could help understand the wiring for it that would be great

 

[7d9_z28]

these are the wires for my code3 TA (red, red/white, yellow, orange, blue, brown, purple) so if anyone could help understand the wiring for it that would be great

Again, refer to the link in my post above. On page 5 there is a diagram on exactly how to hook them all up.


http://www.code3pse.com/public/media/inst_as-847_839_6fl_arrowstik_t02784_rev_20.pdf


Page 5, Figure 7