Code3 6 Up LED's

[C17LVFD]

Good Evening everyone,

Have a question, just got some 6ups that each have a circuit board on the back of them. They were out of a 2100 series bar. The wires are in less than favorable condition, and I'm wondering if I can run the LEDs off the two wires going into the circuit board... so my real question is are these circuit boards some kind of ballast or are they passive and these boards are just flashers?

Thanks so much,
Seth

 

[ERM]

Hey Seth. Post a pic. It depends, but I can tell you by seeing the board.

Tony

 

[C17LVFD]

Thanks Tony. Here are pics...

 

[ERM]

Hi Seth,

This new forum doesn't notify you when new posts are made. Didn't check until just now.

The wires are horrible, but you must use this circuit board as it is the regulator for the LEDs. There should be a steady burn pattern as one of the patterns.

Tony

 

[C17LVFD]

Thanks Tony

Sett