I am about to start the planning process for my custom built Liberty Lightbar. My friend has a Liberty but it has the side by side LR11 takedowns. Is there a special bracket that is required for that. Also is there a place where I can buy the replacement two pin plugs so I can make a harness so one connector can power the two LR11's
Dual LR11 Takedowns?
- Thread starter Aidan Bahner
- Start date
Sparky_911
Supporting Donor
So from this
To this?
No special brackets needed...just remove the black metal panel from the base and they should bolt right in. At least mine did.....
As for pins and molex connectors I used allied electronics. You'll hafta invest in a pin tool, total investment for me was about 40 but I now have the crimper, pin removal tool and still have about 20pins and 20 molex plastics left.
To this?
No special brackets needed...just remove the black metal panel from the base and they should bolt right in. At least mine did.....
As for pins and molex connectors I used allied electronics. You'll hafta invest in a pin tool, total investment for me was about 40 but I now have the crimper, pin removal tool and still have about 20pins and 20 molex plastics left.
The dual LR11 brackets for the Liberty look like this:
Source: https://elightbars.org/forums/threads/whelen-dual-lr-11s-super-led-takedowns.82567/
Source: https://elightbars.org/forums/threads/whelen-dual-lr-11s-super-led-takedowns.82567/