OTFD211
Member
Ok guys here is my situation..... I have a split dual color (R/B & A) Fusion ILB. I also have 2 Fusion 2X in dual R/A. I'm attempting to take the dual R/A modules out of the 2Xs and swap them with the B/A in the ILB so that I can have all RED or AMBER depending on mode selection. Here's my problem....I can't get the R/A out of the 2Xs to work in the ILB. I've discovered that the 2X heads are self contained but can't figure the wiring correctly on the ILB. As soon as I hook up the sync wire the head stops working. All lightheads are interior only and have the 4 wires...RED/AMBER/BLUE/BLACK. Here is another issue I've found...this might be the correct functions I'm not sure....
2X head: R- mode 1
Y- mode 2
Blue-Sync
Black-Ground
Dummy head: R- nothing
Y- nothing
R/Y together-mode 1
Blue/Black -ground
ok guys I realize this is a little long but trying to give some background on what I have gotten so far. I assumed before I started this that all that was needed was to put each mode into steady burn and I would be good. I already have a email into Feniex but I think I will get a faster reply from everybody here. Anybody have any input/ideas? Is this even possible? Thanks for any help you guys can give. Bill
2X head: R- mode 1
Y- mode 2
Blue-Sync
Black-Ground
Dummy head: R- nothing
Y- nothing
R/Y together-mode 1
Blue/Black -ground
ok guys I realize this is a little long but trying to give some background on what I have gotten so far. I assumed before I started this that all that was needed was to put each mode into steady burn and I would be good. I already have a email into Feniex but I think I will get a faster reply from everybody here. Anybody have any input/ideas? Is this even possible? Thanks for any help you guys can give. Bill