Explorer dude
New Member
i have an etl5000 light bar. I am trying to change the flash pattern and I think I need to get to the breaker box? Where would this be located? And how do I change the pattern?
Well if you actually looked at the link I posted...it shows on page one that the white wire is the pattern select wire. On page two it states: "Pattern Select - Momentarily activating the pattern select input will cause the activated light heads to advance one flash pattern. Also, when used in conjuntion with the cruise mode pattern select input will toggle the cruise mode setting."Thanks. But how do I advance the flash pattern?
Tap it to 12v then release. Each time you do that should advance the pattern.Not trying to be difficult, promise. I found the white wire, what do I touch the white wire with, or what do I connect it to, so the pattern changes?