I decided to put Whelan LED strobe lights in the reverse lights of my 2024 Expedition. There is a nice flat surface on the bottom of the reverse light to drill the 1" hole, and I have some RTV sealant to make it waterproof.
What I cant figure out is how to run the wire. There is an extra rubber gasket over a hole that leads to the inside of the vehicle, but I can't fish the wire through. Should I be trying to go high or low? It seems like there is nothing but steel behind that hole.
Any help would be appreciated.
What I cant figure out is how to run the wire. There is an extra rubber gasket over a hole that leads to the inside of the vehicle, but I can't fish the wire through. Should I be trying to go high or low? It seems like there is nothing but steel behind that hole.
Any help would be appreciated.