FiremanSketch
Member
I'm going to do my best to formulate my question into written words, so bear with me if it comes out a little cattywompus...
Liberty SX. I'm sure like some of you, I suffer from the paradox of wanting to change up flash patterns from time to time, but also suffer from "once it's installed, I'm not touching it again until I take it out." But for the sake of the thread, let's say all the heads are on Signalert, and I decided I wanted the center 2 heads to single 120. If I unplugged all the lightheads minus the above mentioned 2, powered on the bar, selected my pattern, and reapplied the remaining heads, will they still be on Signalert, or will they all be single 120 since power was applied to all modules at the time of pattern change?
Side note: I'd just figure it out myself, but all my heads are boxed up & getting sent off to Mr. Wilson for a makeover :insert Freddie Mercury fistpump:
Liberty SX. I'm sure like some of you, I suffer from the paradox of wanting to change up flash patterns from time to time, but also suffer from "once it's installed, I'm not touching it again until I take it out." But for the sake of the thread, let's say all the heads are on Signalert, and I decided I wanted the center 2 heads to single 120. If I unplugged all the lightheads minus the above mentioned 2, powered on the bar, selected my pattern, and reapplied the remaining heads, will they still be on Signalert, or will they all be single 120 since power was applied to all modules at the time of pattern change?
Side note: I'd just figure it out myself, but all my heads are boxed up & getting sent off to Mr. Wilson for a makeover :insert Freddie Mercury fistpump: