Fenn
Member
I'm removing the PA650 and installing a HHS2200 in my work ride. PA650 has 4 hot wires going into it that look to be 10 gauge.
The HHS2200 requires 3 8 ga wires.
I'm running a Sound Off Pinnacle lightbar
trigger for hideaway strobes
4 sound off n forces
and a 8 head ultralite
my question is to keep a good amount of power going to this can I put the 4 current incoming hots to a MAXIbus bar and put the 3 hots needed for the HHS2200 on it for power?
I have to leave the 4 in there if at some point I have to switch back or a new car comes in. My options are to use whats there or run 1 new 6 or 8 to a fuse block and use that for the 3 or 4 hookups and remove whats currently there.
ideas?
The HHS2200 requires 3 8 ga wires.
I'm running a Sound Off Pinnacle lightbar
trigger for hideaway strobes
4 sound off n forces
and a 8 head ultralite
my question is to keep a good amount of power going to this can I put the 4 current incoming hots to a MAXIbus bar and put the 3 hots needed for the HHS2200 on it for power?
I have to leave the 4 in there if at some point I have to switch back or a new car comes in. My options are to use whats there or run 1 new 6 or 8 to a fuse block and use that for the 3 or 4 hookups and remove whats currently there.
ideas?