I have an older Whelen UHF2150 HLF. It has the two wire loops coming out the rear of the flasher. I know there are 4 possible flash patterns based on how those 2 loops are either cut or connected but I cannot find a diagram showing how to treat each wire for each pattern. As it is from the factory, both loops are intact and it provides an alternating (I believe) 120FPM. I would like to set it at the slower 90FPM alternate but don't know which wire to cut?
Older Whelen UHF2150 HLF, non scanlock flash patterns
- Thread starter twl911
- Start date
The pattern selection is supposed to be the same as on the UHF2150B:
Source: https://www.whelen.com/wp-content/uploads/2020/08/13531.pdf
In fact, I had an older copy of 13510.pdf from February 16, 2000, which I have uploaded, here:
UHF2150A-Headlight-GrilleLightFlasher_install.pdf
Source: https://www.whelen.com/wp-content/uploads/2020/08/13531.pdf
In fact, I had an older copy of 13510.pdf from February 16, 2000, which I have uploaded, here:
UHF2150A-Headlight-GrilleLightFlasher_install.pdf
Last edited:
