kabsher8093
Member
I'll be doing some standard programming of a pathfinder in a few days. I've gone through the installation manual and the gone over the help tutorial in the software.
Unless I've missed it, I was not able to find out the steps in getting the unit into programming mode.
Do you just plug the programming cable in and it connects automatically or is it like the platinum where you have to push and hold 6, power up, release 6, led flash, press 13.
Unless I've missed it, I was not able to find out the steps in getting the unit into programming mode.
Do you just plug the programming cable in and it connects automatically or is it like the platinum where you have to push and hold 6, power up, release 6, led flash, press 13.
