Rontan led modules

[A-TAD]

I just purchased some Rontan 4led tir style modules. I can see on the board it says Slim light.


These lights have two wires, a black and a red wire with a white connector on the wires.


Some of the lights are missing the connector so I just connected the red to positive and the black to negative but nothing happened.


Do these light need something special to work or are they just dead lights I purchased?


Thanks for any info, A-TAD

 

[Zach C.]

I just purchased some Rontan 4led tir style modules. I can see on the board it says Slim light.
These lights have two wires, a black and a red wire with a white connector on the wires.


Some of the lights are missing the connector so I just connected the red to positive and the black to negative but nothing happened.


Do these light need something special to work or are they just dead lights I purchased?


Thanks for any info, A-TAD

What do the connectors look like? I am pretty sure the modules need a ballast to flash.


Zach

 

[A-TAD]

The connector is real tiny, maybe 1/4 inch wide. Just a little bigger that the wires themselves.


Well if they need a ballast, I'll list them cheap in the for sale/trade post. I have six if anyone needs them.


I was going to use them in my knock off code-3 2100 bar.

 

[Zach C.]

The connector is real tiny, maybe 1/4 inch wide. Just a little bigger that the wires themselves.
Well if they need a ballast, I'll list them cheap in the for sale/trade post. I have six if anyone needs them.


I was going to use them in my knock off code-3 2100 bar.

I had a rontan bar that sounds like it used the same lightheads. It needed ballasts to flash but do NOT hook them up to 12v as they well burn the led up.


Zach