T3 Syncing Issue

Discussion in 'Feniex Industries' started by tbrown, Aug 11, 2017.

  1. tbrown

    tbrown New Member

    I have a pair of T3's that I'm having issues with getting to alternate. I'm able to set one to master and one to slave, but can only get them to alternate in a slow flash pattern. If I try to change patterns, they still alternate, but are on different flash patterns.

    Any tricks or anything I could be doing wrong?
     
  2. Jarred J.

    Jarred J. Archive Expert Silver Level Member

    When you set them as master slave leave the sync wires attached and touch them both to ground momentarily at the same time...

    Easiest way to do it is set both lights to steady and go from there
     
  3. FEVER

    FEVER Platinum Level Member

    Make sure you don't try to change the patterns too dash. Only one will change.
     

Share This Page