Wecan Control Wire

FusionWolf

Member
Looking for suggestions on where to buy Wecan Control wire. I have a CANEM16 expansion module that I'm looking to install in the engine bay of my car. Looking at the instructions it says to extend this using 3 wire twisted (7 twists per foot)

What wire have yall been using to accomplish this? Is there a specific type of wire you have to use or can I just twist 3 16g wires together?
 
OP
OP
FusionWolf

FusionWolf

Member
i just twist 2 16ga wires together in a drill and it works fine. Iv seen people use strobe wire as well.
Oh ok that's perfect then. I didnt know if it needed to be shielded or have drain wires or what not. Thank you so much
 

Online statistics

Members online
5
Guests online
141
Total visitors
146

Members online

Forum statistics

Threads
48,290
Messages
422,202
Unanswered questions
8
Members
17,379
Latest member
Marauderleader
Top Bottom