Whelen CenCom Saphire and ION

[Evan]

Hello ELightbar community,
I am looking to wire Some ION (R, B, J) to a CenCom Sapphire
Looking at the diagram for the ION and the Sapphire I understand them both separately. I just don't understand how to merge the two together. Any guidance on how to connect the two would be greatly appreciated.
Thank you

 

[NoLimitSquads]

On a Sapphire, the outputs are either on, or off. So set the flash patterns on your Ions, ground all of the black wires, and hook all of the Ion 12v+ wires to the desired output on the Sapphire, usually output 1,2, or 3. If you want your Ions to sync, hook all of the gray wires together.

 

[Evan]

On a Sapphire, the outputs are either on, or off. So set the flash patterns on your Ions, ground all of the black wires, and hook all of the Ion 12v+ wires to the desired output on the Sapphire, usually output 1,2, or 3. If you want your Ions to sync, hook all of the gray wires together.

Okay Awesome Thanks! That makes sense. Ill prob wire them into outputs 4-7 as that can free up the higher amps