fireman616wfd
Member
I have a lower rear deck inner edge for a Charger that was manufactured in 2010. It is on scanlock patterns and I am trying to get it off scanlock. I had one of these for a crown victoria and the flasher board was an actual flasher and had a scan lock wire coming from it. How do I get this one off scanlock patterns and on to just normal patterns.
They wire leads coming out are as follows and i will put what they are doing when 12V applied.
Red 12+
Black - Ground
Blue - warning patterns (scanlock)
White/Black - traffic director right
Orange - traffic director left
White/Green - Low Power
Brown - nothing
White - nothing
White/Orange - pattern change
They wire leads coming out are as follows and i will put what they are doing when 12V applied.
Red 12+
Black - Ground
Blue - warning patterns (scanlock)
White/Black - traffic director right
Orange - traffic director left
White/Green - Low Power
Brown - nothing
White - nothing
White/Orange - pattern change