HCR1990
Member
In May of 21, I decided to treat myself and purchased a 2014 charger 3.6l pursuit. When I purchased it from the dealer it came completely upfitted, cage, laptop stand, jotto console, lights,sirens, radar, and even the graphics. Sadly it came installed with a brookings lightbar and a Carson controller/siren, two off brand red/blue split 6led grille lights and some vertex in the backup lights. While I ran with it for a short time, I disliked the lack of flash patterns and siren tones, I switched it out for my TX DPS liberty and a Cencom Sapphire, replaced the grille lights with IONS and mounted some M4s in the fog light area.
In August of 22 I left the PD and was left with no option but to remove the graphics, seeing as I was no longer an officer(no impersonation here).
Annoyed with the lightbar on top screaming, even moreso now, “IM A WHACKER”, I found an inner edge XLP and 500 series rear deck inner edge and installed those.
So she sits now with no graphics and an interior setup.
I am still on the lookout for an XLP Wecan control board to switch out the LC and have contemplated doing a custom job on the rear deck bar using the Duo R/B/A modules and the we can control board from the liberty, just haven’t taken the time to sit down and look to see about the mounting of the lights in the housing
Front:
Rear:
In August of 22 I left the PD and was left with no option but to remove the graphics, seeing as I was no longer an officer(no impersonation here).
Annoyed with the lightbar on top screaming, even moreso now, “IM A WHACKER”, I found an inner edge XLP and 500 series rear deck inner edge and installed those.
So she sits now with no graphics and an interior setup.
I am still on the lookout for an XLP Wecan control board to switch out the LC and have contemplated doing a custom job on the rear deck bar using the Duo R/B/A modules and the we can control board from the liberty, just haven’t taken the time to sit down and look to see about the mounting of the lights in the housing
Front:
Rear: