ChargerLighting
Member
For a Whelen Edge wrecker bar build I'm doing, I needed to figure out how to add S/T/T lights & keep cost down.
Instead of paying $17 - $20 ea. for Whelen's version of the 1157 bulb, I decided to use a set of MX7000 S/T/Ts I had laying around.
The factory MX S/T/T bracket wouldn't fit, so I removed it & happened to grab an MX7000 rotator deck plate bracket.
It fits great in the Edge's frame & is reversible to mount the lights further in or out (in my case I flipped them inward to keep the STT bulb away from the lens).
Wasn't sure if anyone had thought of this yet or not, but there are tons of these MX brackets out there & they are pretty ridgid.
Might be a good solution to those making their own custom Freedoms, 9Ms, 9000s, etc. using their own LEDs.
I double stacked a couple sho-me LEDs on 1 bracket & they fit.
Hopefully this will help somebody out.
Instead of paying $17 - $20 ea. for Whelen's version of the 1157 bulb, I decided to use a set of MX7000 S/T/Ts I had laying around.
The factory MX S/T/T bracket wouldn't fit, so I removed it & happened to grab an MX7000 rotator deck plate bracket.
It fits great in the Edge's frame & is reversible to mount the lights further in or out (in my case I flipped them inward to keep the STT bulb away from the lens).
Wasn't sure if anyone had thought of this yet or not, but there are tons of these MX brackets out there & they are pretty ridgid.
Might be a good solution to those making their own custom Freedoms, 9Ms, 9000s, etc. using their own LEDs.
I double stacked a couple sho-me LEDs on 1 bracket & they fit.
Hopefully this will help somebody out.