WhelenNDealin
Member
I got an as-is Sapphire brain for cheap. Rolled the dice right there. Got all of the cables and a control head. Powers up fine, relays work and the siren driver works. WeCan light is steady green. get a double flash on the error light. Looked at manual and it says check bar i/o. No bar's connected so that might be it. Using the WC port anyways.
Thing is that when I connect the USB cable to program it, the computer registers the brain, but Command says not connected. Ok ran into this with my old HHS2200. I'd disconnect the unit from power and reconnect and it'd be fine or I'd disconnect the USB cable and reconnect it or do both and it'd be fine.
Tried this with the Sapphire and same deal, computer registers it but Command doesn't.
What's going on here? Hopefully not a dead USB port. That'd be the same as a dead brain imho.
Thing is that when I connect the USB cable to program it, the computer registers the brain, but Command says not connected. Ok ran into this with my old HHS2200. I'd disconnect the unit from power and reconnect and it'd be fine or I'd disconnect the USB cable and reconnect it or do both and it'd be fine.
Tried this with the Sapphire and same deal, computer registers it but Command doesn't.
What's going on here? Hopefully not a dead USB port. That'd be the same as a dead brain imho.