dudek_peter
Member
- Dec 27, 2014
- 21
I have a DUO liberty 1 WC ( built in 2013) connected to a sapphire. I’m trying to have the bar do a left right pattern. I’ll set the drivers side bar to phase 0 and set the passenger side bar to 180. It plays properly on command software and when I transfer it to the sapphire it changes it to the 4 corners to phase 0 and the 4 inboards to phase 180. I tried using the pre legacy check box and when I use that the entire bar just goes to steady burn. I also tried to rebuild the bar in both WeCad and Command but I can’t figure out or find a Liberty 1 DUO WC. Any ideas on what could be wrong.