roaddawg7
Member
Got a used whelen t/a bar TAD8 with whelen controller TADCTL1 but the wires were cut. I have connected them all back together but I have a white w/ red stripe with no ends left from the bar to connect it to. I've looked up the wiring and it shows that wire is for the flash mode. I want to use the flash mode on the control box, so what wire do I swap out or is it left out.
From the bar- black, green, red, blue, orange, white
From controller- black, green, red, blue, orange, white, white w/ red stripe
From the bar- black, green, red, blue, orange, white
From controller- black, green, red, blue, orange, white, white w/ red stripe
Last edited by a moderator: