'08 jeep GC Horn Ring Transfer

[firebuff17]

Looking for alittle wire schematic and location help.


Putting in a Whelen PAH112 in my second vehicle. It's a 2008 Jeep Grand Cherokee. Just need location and wire color where I can cut and splice a horn ring transfer to power the activation wire on my PAH 112. I am putting in a switch to select AH or OEM horn.


Thanks ladies and gents

 

[andrewsim]

On my 08 I was already doing work under the hood, so this wasn't a big deal for me. On the drivers side is a horn, the factory wire splits there and runs to the passenger side horn. Before the split, I intercepted the factory wire and ran it to a 5-pin relay in a project box under the hood.


The remote start install people are saying it is:


HORN | DK. GREEN/ORANGE (+) | @ HORNS or IPM, (PLUG(C2) PIN 35, NOTE #6 (Note 6:the IPM (INTEGRATED POWER MODULE) is located in the Engine Compartment, on the Drivers Fender.)


I think horns would be the easiest way.

 

[firebuff17]

Thanks for the reply.


I was hoping that there was a connection spot in the drivers footwell just for ease of installation but does not look that way because this is the only thing I am installing.


Thanks for the info on it.