9M flasher

[amccullers]

I want to use a 9M flasher, P/N 01-0269289 from the power distribution board for a mini bar project. But I can get it to work, I applied power to the to the 2 pin connector labeled BATT. Do I need to apply power to one of the pins in the female 4 connector that is vertical? 

[Broken External Image]:[URL]http://i170.photobucket.com/albums/u259/amccullers/Mobile%20Uploads/20140531_162624_zpsc2x6cyfk.jpg[/URL]

Thanks

Andrew

 

[got_yogurt]

I believe you do need to apply power to another pin as well, but I have no idea which one

 

[emtanderson51]

I want to use a 9M flasher, P/N 01-0269289 from the power distribution board for a mini bar project. But I can get it to work, I applied power to the to the 2 pin connector labeled BATT. Do I need to apply power to one of the pins in the female 4 connector that is vertical? 

[Broken External Image]:[URL]http://i170.photobucket.com/albums/u259/amccullers/Mobile%20Uploads/20140531_162624_zpsc2x6cyfk.jpg[/URL]

Thanks

Andrew

The vertical 4 pin connector on the lower left hand side are your triggers for front or rear flashing and steady burn override. You need to apply +/- to the center 2 pin connector and + to the function you want powered in the lower 4 pin harness.

 

[amccullers]

Thanks I will try it again.