Anyone tell me the dimensions of these?

[shott8283]

I was wondering if anyone could measure or tell me off hand what the dimensions of these legend labels are?


I have a 10 switch whelen switch box that I need to relabel and it uses some really small real estate for the each label so the regular white FS stickers wont cut it


unless anyone has any ideas how to make there own and have them look factory


thakns!!!!


ETA almost forgot to post the listing http://cgi.ebay.com/FEDERAL-SIGNAL-CODE-3-Other-Switch-Legend-Sheet-/150559756174?pt=LH_DefaultDomain_2&hash=item230e0f8f8e

 

[RecElect]

Our legend sheet has 600 legends and they are .34 x .34 for dimensions. They are backlightable, and are made from a plastic like material, probably the same stuff the FS ones are.


We have them listed for $45, but if you enter "code3" in the coupon box it will give you them for $30 and free shipping.


http://www.shopwiredhdh.com/servlet/the-8/Legends/Detail


Thanks!

 

[shott8283]

Our legend sheet has 600 legends and they are .34 x .34 for dimensions. They are backlightable, and are made from a plastic like material, probably the same stuff the FS ones are.

We have them listed for $45, but if you enter "code3" in the coupon box it will give you them for $30 and free shipping.


http://www.shopwiredhdh.com/servlet/the-8/Legends/Detail


Thanks!

ok thanks for the link


i just measured the stock ones that are crap and they are .47 by .34


so yours would work .. just seeing if there are any ones that exact size.

 

[ryanm]

I have used the FS label sheets with the whelen switchboxes before.


The labels are not quite big enough, but you can darken around the edge with a sharpie and have it looking pretty good.

 

[shott8283]

ok. thanks guys!


i got the sheet from the ebay link on the way. if they dont work out then i might try the HDH ones.