Sparky_911
Supporting Donor
Did an install using materials I had around my shop. This is on my 16ft jon boat that I use for play and if needed water rescue. I used lighting from Feniex and Strobesnmore for navigation/marker lighting and search lights. Here goes....
My original idea for night lighting was 2 SNM eflood 7560s on the front and 2 eflood 7200 down the sides and add a PVC rack to the rear with 360 deg Feniex Titan modules.
After getting the 7560s in and modifying them (see my 7560 review thread), it is MORE than enough for my use.
For the flood/spot lights I used 2inch PVC pipe clamped to the deck wall to hold the light towers (made of 1.5 inch PVC conduit) and some hitch pins to raise/lower the towers. Covered the whole thing in Rust-o-leum sprayon bed liner.
For wiring I used 14ga G/B/W/Y trailer wiring, took a stick of 3/4inch PVC conduit, ripped it lengthwise, and cut it into short sections to secure the wiring along the gunwale. I used a piece of 3inch pvc for a switch box and used 1/2inch ag sprayer hose to run wires thru the end cap.
For nav lights I used 2 Feniex T3s set on the "dim mode" pattern and mounted them using 1inch aluminum angle iron/square tubing. For the rear white I used a 12 dollar pontoon light and mounted it on a 1inch stick of PVC 3ft tall.
And I keep a blue LED throw beacon onboard for use during rescue calls.
My original idea for night lighting was 2 SNM eflood 7560s on the front and 2 eflood 7200 down the sides and add a PVC rack to the rear with 360 deg Feniex Titan modules.
After getting the 7560s in and modifying them (see my 7560 review thread), it is MORE than enough for my use.
For the flood/spot lights I used 2inch PVC pipe clamped to the deck wall to hold the light towers (made of 1.5 inch PVC conduit) and some hitch pins to raise/lower the towers. Covered the whole thing in Rust-o-leum sprayon bed liner.
For wiring I used 14ga G/B/W/Y trailer wiring, took a stick of 3/4inch PVC conduit, ripped it lengthwise, and cut it into short sections to secure the wiring along the gunwale. I used a piece of 3inch pvc for a switch box and used 1/2inch ag sprayer hose to run wires thru the end cap.
For nav lights I used 2 Feniex T3s set on the "dim mode" pattern and mounted them using 1inch aluminum angle iron/square tubing. For the rear white I used a 12 dollar pontoon light and mounted it on a 1inch stick of PVC 3ft tall.
And I keep a blue LED throw beacon onboard for use during rescue calls.
Last edited by a moderator: