Am in the process of updating the lighting on my take-home patrol car. For the rear I have settled upon the package but one issue remains for the front. For the front a total of four Code 3 XT3 lightheads are going to be mounts. Two on the front of the pushbumper and one on either side with red on the driver's side (front and side) and blue on the passenger.
My car was previously outfitted with strobe tubes in the corners (CVPI) leaving the plugged holes behind in the housing. Was pondering whether the Hide-A-Blast by Code 3 would sync with the XT3's or if they simply sync with themselves only. The outcome I am looking for is the following as if you were looking at the car from the front and going driver's side to passenger;
Red Hide-A-Blast (Driver Corner) (1)
Red XT3 (Side of Pushbar) (2)
Red XT3 (Front of Pushbar) (1)
Blue XT3 (Front of Pushbar) (2)
Blue XT3 (Side of Pushbar) (1)
Blue Hide-A-Blast (Passenger Corner) (2)
With all heads sync'd, the even labeled lightheads would flash opposing the negative labeled lightheads. Just wondering if this is possible with the Code 3 products.
My car was previously outfitted with strobe tubes in the corners (CVPI) leaving the plugged holes behind in the housing. Was pondering whether the Hide-A-Blast by Code 3 would sync with the XT3's or if they simply sync with themselves only. The outcome I am looking for is the following as if you were looking at the car from the front and going driver's side to passenger;
Red Hide-A-Blast (Driver Corner) (1)
Red XT3 (Side of Pushbar) (2)
Red XT3 (Front of Pushbar) (1)
Blue XT3 (Front of Pushbar) (2)
Blue XT3 (Side of Pushbar) (1)
Blue Hide-A-Blast (Passenger Corner) (2)
With all heads sync'd, the even labeled lightheads would flash opposing the negative labeled lightheads. Just wondering if this is possible with the Code 3 products.