Does anyone have the pinout for the Whelen CC5K1 Canport cable?

[Tango7]

So, after a long wait ($$) I finally got the small parts to accompany the OBD Interface for my Cantrol. Using a hodgepodge of spacers, standoffs and a combination of adapted IC standoffs I got the board installed and recognized. (If it's ugly but it works and it's hidden, who cares).

So I opened up the cable that I'd purchase from a guy who was upgrading from Cantrol to Core, and discovered I had a problem:


I don't know if the guys sent me his Core cord instead of the Cantrol, or if (as I found out surfing for answers last night) his cable was for the "old style" ODB interface which apparently used 6 pins instead of the current 8.

I found a guy who said he'd trade for the cable, but in case he can't find it the title of this post states my request. I can get a 15 foot OBDII cord that's fully populated and run the appropriate pins to the appropriate plugs in the Interface, but the Whelen docs only show a generic diagram for all models:



Thanks all.

 

[NoLimitSquads]

You have a 399k1, a Core Cable. I have a new cc5k1 on the shelf. Here is a better link to the Whelen pin-out, and here are some photos. Let me know if you need anything else.

https://www.whelen.com/wp-content/uploads/2020/08/14A10.pdf

 

[Tango7]

@NoLimitSquads - the guy who needs a Core cable found the CC5K1 NIW, so I'll be swapping with him, but I appreciate the offer.
I had the pinout for the Whelen side, was looking for the OBD side. When mine arrives I'll grab my meter and work up a chart in case anyone needs one in the future.