Installers recomendations for Power Distribution...

[G1159]

Looking for some of your favorite products for power distribution.


Large guage power wire Split to two 8 guage power inputs to Whelen HHS. 30 amp relays for front and rear warning groups from two 10 amp assignable outputs on HHS. Also splitting out for a group of radios and other various accessories.


Any ideas for Ways to do Power Distribution?


For grille, dominator, and fog light LEDs, just split it under hood or run seperate zips for each from the 30 amp relay for front?


Looking for best practices and to trigger some good discussion.


Thanks.

 

[litning]

for distribution (and fuse protection) I use this product: http://bluesea.com/category/5/21/productline/126


Each system (driving lights, grill lights, rears, sides, hlf, etc) has its own relay, whether individual bosch relays or something like the Whelen PCC8R.


That's how I've wired the vehicles I have done.

 

[GaryErrol]

for distribution (and fuse protection) I use this product: http://bluesea.com/category/5/21/productline/126

I'm also using that very distribution block and also highly recommend it.

 

[Abacus]

+1 on the Blue Sea but just the 6 and the Whelen PCC8R. Happy thanksgiving

 

[Strobesnmore]

Are you going to be exceeding the 10 amp output of the swtiches? Is that the reasoning behind the relays? You may not need to run the full power to the switch portion of the HHS if you are going to be using draw far below the max.