Running wires for 2009 Charger license plate leds

[NC lawdog]

Just wondering if anyone can give me some ides on how to run license plate LEDs without having to drill holes in the bumper. I have 2 Code 3 XT3s that I'll be mounting on a bracket. I thought about running the wiring up through the top of the license plate but I can't find an open place to bring them out. Any ideas, pics, cave drawings, etc would be appreciated!

 

[ParkPiggy]

I'd drill a hole behind the plate, where they will never be seen. If I recall, some of the TIR3/LIN3 LP mounts, attach to the LP screws-so the plate and bracket are anchored by the same bolts.

 

[EL1998P71]

You can run the wires up thru where the license plate light is.


It's a decent size hole. about 1/2" by 2"


Remove the passenger side tail light.


Below is a rubber boot for the license plate light.


You can run the wires thru that.


No holes drilled

 

[NC lawdog]

You can run the wires up thru where the license plate light is.
It's a decent size hole. about 1/2" by 2"


Remove the passenger side tail light.


Below is a rubber boot for the license plate light.


You can run the wires thru that.


No holes drilled

I hadn't gotten around to removing the tail light to see what was back there. Thanks and I'll post some pics once I get the install done.