billyfromhill
Member
I have a Carson SC-1012 wired to a Feniex 100W speaker. Just this week, it started to sound quiet. Took everything apart, made sure the connections are all good, but still not fixed. I have good continuity through the speaker and my meter reads 10.2 Ohms through the speaker. I disconnected both ends of the speaker wiring to check for shorts. When tested with a multimeter, the wires do not have continuity to each other or to ground. I do have continuity between the speaker pins on the amplifier. When I test the amplifier without the speaker connected, I hear the proper tone coming from the amp. Both the siren and speaker were purchased new and have been installed for less than 6 months. I do not have another amp or speaker to test with.
Is there anything else I can do to try to eliminate the speaker/wiring? I'm thinking I may have a bad speaker.
Is there anything else I can do to try to eliminate the speaker/wiring? I'm thinking I may have a bad speaker.