Wecan issue

[fam29]

Hello all, I've been trying to change the flash pattern on my Liberty II bar utilizing the Wecan software.

I'm able to see the bar when I extract the information from it and I'm able to change the front flash pattern. The issue I have is, the rear pattern doesn't change to what I've selected even though it shows it on the Whelen Wecan screen. Any ideas how to make it work?

 

[PJH]

Check what wire/connection you selected and ensure that you have front and rear lightheads selected. Its been a little bit since I had to adjust one, but I know the software seems a little goofy on slower computers. If you can, email me the file and I can take a look at it.

 

[fam29]

I may have gotten it figured out. I deleted the pattern and recreated a new one.