fireman616wfd
Member
So I am about to install two Whelen Outer Edges (top & C pillar edge) on my Tahoe PPV. They will be all blue. I also have a pair of M7's flush mounted on my rear liftgate.
-What i want: I want to sync the heads on my upper outer edge with my C-Pillar outer edges (have no clue how im going to sync the up yet whether its solid bar on each side in a X pattern or each head alernate BUT anyways..) and im thinking about syncing the Whelen M7's with the outer edges but not sure yet. I need two options here, 1 is for them to flash sync which is easy enough but 2.) I want atleast 1 pair of the LINz6's on my top outer edge and may do the center LINz6's on my c-pillar edge to do steady burn/cruise mode for "safety checkpoints" which we do alot of, if i happen to be on a call (domestic or whatever) or anything I may want to assist on a stop and use my steady burn blue with amber TD bar behind window rather than activating all rear lights. My front Nforce bar will be hooked up on same switch to have one or two pair of heads in it to steady/cruise also.
-Problem: HOW DO I MAKE THIS HAPPEN without the entire rear outer edges going to a steady burn? Is there a flasher out there like the ERM that has two "Modes" but also has seperate switching on inputs? like mode one would be steady burn for only two heads in the rear which means i hook it to #1& #2 inputs but & mode 2 flashes and all my outer edge heads are hooked to #3 & #4 inputs to alternate.
Any ideas or suggestions?
-What i want: I want to sync the heads on my upper outer edge with my C-Pillar outer edges (have no clue how im going to sync the up yet whether its solid bar on each side in a X pattern or each head alernate BUT anyways..) and im thinking about syncing the Whelen M7's with the outer edges but not sure yet. I need two options here, 1 is for them to flash sync which is easy enough but 2.) I want atleast 1 pair of the LINz6's on my top outer edge and may do the center LINz6's on my c-pillar edge to do steady burn/cruise mode for "safety checkpoints" which we do alot of, if i happen to be on a call (domestic or whatever) or anything I may want to assist on a stop and use my steady burn blue with amber TD bar behind window rather than activating all rear lights. My front Nforce bar will be hooked up on same switch to have one or two pair of heads in it to steady/cruise also.
-Problem: HOW DO I MAKE THIS HAPPEN without the entire rear outer edges going to a steady burn? Is there a flasher out there like the ERM that has two "Modes" but also has seperate switching on inputs? like mode one would be steady burn for only two heads in the rear which means i hook it to #1& #2 inputs but & mode 2 flashes and all my outer edge heads are hooked to #3 & #4 inputs to alternate.
Any ideas or suggestions?