Jordan_TCFD
Member
I have an all blue 48 inch Millennium lightbar. It was working just fine, just a few LED's not working. I hooked everything up again and after just a few minutes it does not want to work any more. I have full 13.5-7 volts, have the CID powered and the bar powered. When I turn the power supply on some of the LED's flash for a half second on the bar, but that's it. The green light is on, the red and yellow will flash some times. Nothing consistent. With this testing session, the green and yellow were on. Then something happened and everything stopped working.
I have searched Google and here and haven't found much information on this. I don't have another CID box to test, so can't do anything like that.
I was going to try to change the LED's to red/amber and put on one of our trucks, but if I can't get it working properly, then I'll just scrap the idea(and possibly the bar).
I know these bars are notorious for problems, so I'm not surprised with this. I thought I had a working bar, but apparently not.
I have searched Google and here and haven't found much information on this. I don't have another CID box to test, so can't do anything like that.
I was going to try to change the LED's to red/amber and put on one of our trucks, but if I can't get it working properly, then I'll just scrap the idea(and possibly the bar).
I know these bars are notorious for problems, so I'm not surprised with this. I thought I had a working bar, but apparently not.