nightwolf
Member
So I failed to heed the warning you guys gave me and purchased some B/A cannons for the turn signal of my bike. The good news is the flange is almost exactly the same size as the blinker housing so with a little work it should look pretty clean.
The cannons are too bright to be used as turn signals, even with 6 leds on. What size resistor would you reccomend me using for mode 1 (steady-burn to be flashed by blinker relay). Another member here noted they used a 22 ohm resistor for parking light (very dim) and an 8 ohm resistor for their blinker (little noticeable decrease in brightness). I'm planning on going somewhere between the two, any ideas on a good number?
The cannons are too bright to be used as turn signals, even with 6 leds on. What size resistor would you reccomend me using for mode 1 (steady-burn to be flashed by blinker relay). Another member here noted they used a 22 ohm resistor for parking light (very dim) and an 8 ohm resistor for their blinker (little noticeable decrease in brightness). I'm planning on going somewhere between the two, any ideas on a good number?