11b101abn
New Member
Here ya go:
Currently, in mode 1 ( pos 1 on slide switch), I have rear bar outer LED's only and rear hide-a-ways.
If I were to incorporate, say, the Warn 3 pattern onto that switch position, would Warn 3 still be the rear flash pattern on Modes 2 and 3?
I read the install manual and I wasn't able to find it.
UPDATE---- Finally got some time carved out and mucked about w/ the function wires. Apparently, once a warn pattern is activated, it will override any emergency pattern in the rear of the bar regradless of the mode the lighbar is in.
Example: If you activate Pattern 20, or whatever, and you activate the wire that controls warn 1, then warn 1 will override the emergency pattern through ALL of the warning modes. If you assign warn 2 to the second position on your slide switch, then it will over ride warn 1, and so on.
Clear as mud?
Currently, in mode 1 ( pos 1 on slide switch), I have rear bar outer LED's only and rear hide-a-ways.
If I were to incorporate, say, the Warn 3 pattern onto that switch position, would Warn 3 still be the rear flash pattern on Modes 2 and 3?
I read the install manual and I wasn't able to find it.
UPDATE---- Finally got some time carved out and mucked about w/ the function wires. Apparently, once a warn pattern is activated, it will override any emergency pattern in the rear of the bar regradless of the mode the lighbar is in.
Example: If you activate Pattern 20, or whatever, and you activate the wire that controls warn 1, then warn 1 will override the emergency pattern through ALL of the warning modes. If you assign warn 2 to the second position on your slide switch, then it will over ride warn 1, and so on.
Clear as mud?
Last edited by a moderator: