Liberty SC cruise lights

[hipeople159]

Hello, I'm a bit confused as to how to program a button (on the MPC01, using the SC software) to activate cruise lights. There appears to be a checkbox for cruise lights in the lightbar configuration stage, but I still don't know what to do. Any help would be appreciated.

 

[Nolines]

I can check tomorrow when I get to work I have the software on my laptop.

 

[Nolines]

Ok started playing with my software this morning and tried animating to see what it does but haven't had any luck so I sent a tech support question to the guy I'm dealing with to get a better idea what's going on, is it automatic when you turn on the mpc01 or what I asked and a few other questions, so I'll see what he says back to me.

 

[RS485]

Could it be that its treated as "Auxiliary output" when assigning button actions?

 

[Nolines]

I asked him he says If he is using a liberty SC bar then the cruise lights can be turned on in any switch position.

I'm like ( face palm ) how???? I'm thinking turn that option on and program the bar/mpc and then see what happens when he turns it off then on.

 

[hipeople159]

Would've been much easier to just put a "Steady" option for the corners like the regular modules do. I'll try checking that checkbox and assigning aux 1 or 2 to a button.

 

[Ranger-Services.com]

its the aux checkbox,
edge 9u strobe, aux option
patriot aux option
liberty aux option, but not all IO boards support corner cruise
freedom same as liberty

 

[dmorrill22]

I've been wondering this too. Couldn't find a way to get the hex code for it to send to an sc bar to test either

 

[Ranger-Services.com]

I've been wondering this too. Couldn't find a way to get the hex code for it to send to an sc bar to test either

for liberty/freedom its not the programming, its the actual IO board that does or does not have the support for it