Hello all, I have a Whelen Liberty bar-Model SL8BBBB. I want to change the pattern on the led heads, but the White/Violet wire is not changing them. I have tried doing one pair at a time, but it still does nothing. Any Ideas?
Whelen liberty pattern change issue
- Thread starter bjm1204
- Start date
you may want to open the lightbar up and see if the pin into the I/O board is properly installed into the connector.
I have opened the bar up and traced down the white/violet wire . Once it enters the lightbar-it is not connected to another wire-it dead ends at the connector. Any ideas? Is it possible to change the patterns another way?
is there a personality module on the I/O board ? and have you tried providing 12v to the backside of the connector on the white/violet wire to rule out a possible broken white/violet wire ?
The white/violet wire is not connected to anything at all-like I said, once it enters the bar-it enters a 4 wire connector and there is nothing that exits the other side of the connector.