Search results

TY is $25 ok

I’ll buy send a pic, price

Looking for a Green lens /filter for my mini LP metal rotator not free form

Thanks guys if I have any further issues I’ll be here to ask

Whom ever installed the last one it was already bent, your right it’s just frustrating, if I knew the issue with this bar I would’ve gone a different route yet again it’s a learning experience.

What’s the recommended size cotter-pin if you recall

Anyone have any solution on how to, I don’t own the correct equipment to install correctly

Hello fellas. Just purchased a replica worm gear off of eBay, I sent a message to the owner, haven’t seen a response, I know it’s hard now since this outbreak. If anyone knows who’s selling on eBay please help.. thank you :)

They should last as long as the originals.. but the original plastics are different than what is used today.

Thank you I’ll keep that in mind :^) If I have anymore questions I’ll be back

Ok thank you, do you have a bulkhead, what are your prices for the domes.. figures out what was the cause. Wasn’t grounded properly. Rewired so there wasn’t any shorts. I’m using a 55 watt powermax converter.

Just tried to connect the flasher it kills the bar I know it’s not the power supply because Just plugged in my sealed beam xl and it works fine.. maybe it’s the flasher, I’ve seen your video on the correct unit a cam flasher Where may I purchase a cam flasher that has the X pattern

New belt sounds nice getting a new idler gear from a good friend we know

Ok fixed the issue,,, plugged in another bar to ground reground if that makes no sense. I basically had to unpositive the power supply I’d love to find a new power supply cable

Now since it doesn’t light nor does the motor run I forgot to ground the bar did I blow the motor Took off this back plate to clean, remove some carbon build up, now it doesn’t work. Put on the new belt..

This wobble grease doesn’t work... I’ll find out when. I get the new belt installed. Then I’ll be back here. Looking for help

I’m sure someone here will know

Thank you I’ll try that, what’s the wrench size tiki get the rotators off... where or how to grease the rotators, idler gears is there a special fitting, what’s best or what you use

My inner idlers there bad had the motor removed, removed both left, right idler gears, free hand the inner idler and I’d feels like it gets hung up

Question how to remove the belt inner idler gear, remove the belt without damaging the plastic gears

Timing belt seems to catch every few rotations, it looks like the brass bushings are bad set the timing for LAPD, as it skipped the timing gotten out of wack. Also replacing the timing belt. How do I remove the pins and pin roll without damaging the plastic gears. Cleaned her up and found out...

Ok I’m comparing someone’s sloppy wiring to Stampeed’s video I feel like there’s something missing Found your article

All there stuff doesn’t show... either it’s outdated.. be nice to see some old skool Aerodynic catalogs from the mid 80’s

They used a red wire as a ground

It’s a 1987 someone required the bar so there red power orange / red for ground. All but one of the rotators light up, it needs to be greased bad. The flashers are wired to the rotators, I removed the alley’s because I could not figure out which lead went into what. please help your help will...

One thing I’ve learned about collecting vintage lighting is that there all quite unique. If this isn’t the pole for discussion, let me know

Welcome home

Hmm when I’m in the market I’ll contact you,